How to get the diagnostic codes? (Does not work on all
models)
Sit in the driver's seat.
Turn the ignition to the On position, but do not start the engine up.
Immediately depress the accelerator fully and release fully 5 times
quickly.
Wait for a few seconds and you will see the
Check Engine light flash once, then start it will start to blink. All codes
are comprised of 4 digits. The number of blinks corresponds to the fault code.
For example, ON then pause, ON ON then pause, ON ON ON ON then pause, ON ON ON
then off would be a 1243.
Each four digit code will be flashed sequentially. When the codes start to
repeat, all stored codes have been displayed.
Turn the ignition off and check the codes with the table below. 1444 and
2444 means no problem and that is what you hope to find! Good luck!
If this does not work on your model (will
only work on some earlier models), you would
need the
*Disclaimer: The articles presented/submitted on
Bimmerzone.com are for the sole purpose of learning and basic information.
In no way that information provided on Bimmerzone.com be considered
professional advice and Bimmerzone.com will not be held responsible for any
consequences resulting directly or indirectly from reading these articles.
In our articles we mention about brand names and stores, these are for
education, comparison and information purposes only. We do not
specifically endorse any companies.